MediaMatrix nTouch 60 Manuál stáhnout pdf (Strana 61)

NION Hardware Manual

May 17, 2011 Version 1.6.2a.0 57

Each NION will set the actual priority from within the range specified by the user. Each of

these ranges can have two values.

If you want a NION to be an XDAB master or a CobraNet Conductor, set the appropriate range

to be higher than any other device in the cluster.

Notes:

 NWare will normally ensure that the default values are set for proper operation. However,

it may be necessary to manually adjust the settings in order to meet the constraints outlined

in the use cases (on page 49).

 Be aware of the Conductor priority settings of devices outside the XDAB cluster that

reside elsewhere on the network. This point is important when using slave VLANs in order

to insure that a slave device within a cluster remains the CobraNet Conductor.

Tips:

 Explicitly set the CobraNet Conductor priority and XDAB master priority in all devices to

insure they operate correctly.

 Locate the CobraNet Conductor outside an XDAB cluster when possible.

 Set all Conductor priorities to 0 in all devices except those that should be allowed to be

Conductors. For those devices that should be Conductors, make their priorities the same.

 Devices with CM-1 modules are preferred as Conductors over devices that have CM-2

modules.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 97 98

Žádné komentáře

MediaMatrix nTouch 60 Manuál Strana 61