MediaMatrix nTouch 180 Manuál stáhnout pdf (Strana 42)

Chapter 5 - Setting up the nTouch 180 unit

38 Version 1.7.2.0 March 27, 2015

Scenario

Actions to take

do not need to make a selection.

6. Under the Zone box, click Set.

You want the time and date for all

nodes on the network to be obtained

automatically from a single, master

unit.

You do not want anyone to be able to

assign times and dates to the other

units by accessing them directly.

You will specify the time manually.

On the master node:

1. Navigate to the Time and Timezone tab.

2. Clear the Time Server box.

3. In the Authority list, click Master.

4. Click Set.

If you want to adjust the time and date, perform these

steps on the master node:

1. In the Time (24hr) box, type the new time in the

format HH:MM:SS.

2. In the Date (mm/dd/yy) box, type the new date in

the format mm/dd/yy.

3. Under the Date (mm/dd/yy) box, click Set.

4. If you are using a NION, under Timezone,

specify a continent and country.

5. If the country has more than one time zone, in the

Zone list, click the time zone.

Tip: Where a country has only one time zone, you

do not need to make a selection.

6. Under the Zone box, click Set.

On the other (slave) nodes:

1. Navigate to the Time and Timezone tab.

2. Clear the Time Server box.

3. In the Authority list, click normal.

4. Click Set.

Note: If you try to change the time and date

settings on the slave nodes, they will

automatically change to match the settings on the

master node.

You want the time and date for all

nodes on the network to be obtained

automatically from a time server.

On the master (time server) node:

1. Navigate to the Time and Timezone tab.

2. In the Time Server box, type IP address or

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 57 58

Komentáře k této Příručce

Žádné komentáře

MediaMatrix nTouch 180 Manuál Strana 42

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu MediaMatrix nTouch 180